Direct IO Functions
Bevezetés
PHP supports the direct io functions as described in the Posix Standard (Section 6) for performing I/O functions at a lower level than the C-Language stream I/O functions (fopen(), fread(),..). The use of the DIO functions should be considered only when direct control of a device is needed. In all other cases, the standard filesystem functions are more than adequate.
Note: Ez a kiterjesztés átkerült a » PECL tárba és már nem terjesztik a PHP-vel együtt ettÅ‘l a verziótól kezdve: PHP 5.1.0.
This extension is only available on Windows Platforms as of PHP 5.0.0
Követelmények
Az itt leÃrt függvények használatához semmilyen külsÅ‘ függvénykönyvtár megléte nem szükségeltetik.
TelepÃtés
To get these functions to work, you have to configure PHP with --enable-dio.
Előre definiált állandók
Az itt listázott állandókat ez a kiterjesztés definiálja, és csak akkor elérhetÅ‘ek, ha az adott kiterjesztés be van fordÃtva a PHP-be, vagy dinamikusan betöltött.
- c (integer)
- F_DUPFD (integer)
- F_GETFD (integer)
- F_GETFL (integer)
- F_GETLK (integer)
- F_GETOWN (integer)
- F_RDLCK (integer)
- F_SETFL (integer)
- F_SETLK (integer)
- F_SETLKW (integer)
- F_SETOWN (integer)
- F_UNLCK (integer)
- F_WRLCK (integer)
- O_APPEND (integer)
- O_ASYNC (integer)
- O_CREAT (integer)
- O_EXCL (integer)
- O_NDELAY (integer)
- O_NOCTTY (integer)
- O_NONBLOCK (integer)
- O_RDONLY (integer)
- O_RDWR (integer)
- O_SYNC (integer)
- O_TRUNC (integer)
- O_WRONLY (integer)
- S_IRGRP (integer)
- S_IROTH (integer)
- S_IRUSR (integer)
- S_IRWXG (integer)
- S_IRWXO (integer)
- S_IRWXU (integer)
- S_IWGRP (integer)
- S_IWOTH (integer)
- S_IWUSR (integer)
- S_IXGRP (integer)
- S_IXOTH (integer)
- S_IXUSR (integer)
Futásidejű beállÃtások
Ez a kiterjesztés semmilyen konfigurációs beállÃtásokat nem definiál a php.ini állományban.
ErÅ‘forrás tÃpusok
One resource type is defined by this extension: a file descriptor returned by dio_open().
Table of Contents
- dio_close — Closes the file descriptor given by fd
- dio_fcntl — Performs a c library fcntl on fd
- dio_open — Opens a new filename with specified permissions of flags and creation permissions of mode
- dio_read — Reads bytes from a file descriptor
- dio_seek — Seeks to pos on fd from whence
- dio_stat — Gets stat information about the file descriptor fd
- dio_tcsetattr — Sets terminal attributes and baud rate for a serial port
- dio_truncate — Truncates file descriptor fd to offset bytes
- dio_write — Writes data to fd with optional truncation at length