Forum und email

Direct IO Functions

Úvod

PHP supports the direct io functions as described in the Posix Standard (Section 6) for performing I/O functions at a lower level than the C-Language stream I/O functions (fopen(), fread(),..). The use of the DIO functions should be considered only when direct control of a device is needed. In all other cases, the standard filesystem functions are more than adequate.

Note: Toto rozšírenie bolo presunuté do » PECL repozitáru a už neni pribalené s PHP od PHP 5.1.0.

This extension is only available on Windows Platforms as of PHP 5.0.0

Požiadavky

Žiadne externé knižnice nie sú potrebné na vybudovanie tohto rozšírenia.

Inštalácia

To get these functions to work, you have to configure PHP with --enable-dio.

Preddefinované Konštanty

Konštanty uvedené nižšie sú definované týmto rozšírením a budú dostupné iba keď rozšírenie bolo buď kompilované do PHP alebo dynamicky načítané za behu (runtime).

c (integer)

F_DUPFD (integer)

F_GETFD (integer)

F_GETFL (integer)

F_GETLK (integer)

F_GETOWN (integer)

F_RDLCK (integer)

F_SETFL (integer)

F_SETLK (integer)

F_SETLKW (integer)

F_SETOWN (integer)

F_UNLCK (integer)

F_WRLCK (integer)

O_APPEND (integer)

O_ASYNC (integer)

O_CREAT (integer)

O_EXCL (integer)

O_NDELAY (integer)

O_NOCTTY (integer)

O_NONBLOCK (integer)

O_RDONLY (integer)

O_RDWR (integer)

O_SYNC (integer)

O_TRUNC (integer)

O_WRONLY (integer)

S_IRGRP (integer)

S_IROTH (integer)

S_IRUSR (integer)

S_IRWXG (integer)

S_IRWXO (integer)

S_IRWXU (integer)

S_IWGRP (integer)

S_IWOTH (integer)

S_IWUSR (integer)

S_IXGRP (integer)

S_IXOTH (integer)

S_IXUSR (integer)

Runtime Konfigurácia

Toto rozšírenie nemá žiadne konfiguračné direktívy definované v php.ini.

Typy zdrojov

One resource type is defined by this extension: a file descriptor returned by dio_open().

Table of Contents

  • dio_close — Closes the file descriptor given by fd
  • dio_fcntl — Performs a c library fcntl on fd
  • dio_open — Opens a new filename with specified permissions of flags and creation permissions of mode
  • dio_read — Reads bytes from a file descriptor
  • dio_seek — Seeks to pos on fd from whence
  • dio_stat — Gets stat information about the file descriptor fd
  • dio_tcsetattr — Sets terminal attributes and baud rate for a serial port
  • dio_truncate — Truncates file descriptor fd to offset bytes
  • dio_write — Writes data to fd with optional truncation at length